Code: Select all
Warning: PHP CLI requirements failed while executing
""C:\workdata\appdata\php\php.exe" "C:\workdata\code\php\timetrex\/tools/unattended_upgrade.php" --config "C:\workdata\code\php\timetrex\includes\..\timetrex.ini.php" --requirements_only --web_installer"
Likely caused by having two PHP.INI files with different settings.
Code: Select all
C:\Users\dean.mowat\Documents\cmder>"C:\workdata\appdata\php\php.exe" "C:\workdata\code\php\timetrex\/tools/unattended_upgrade.php" --config "C:\workdata\code\php\timetrex\includes\..\timetrex.ini.php" --requirements_only --web_installer
Requirements all pass successfully!
Code: Select all
The filename, directory name, or volume label syntax is incorrect.
The filename, directory name, or volume label syntax is incorrect.
The filename, directory name, or volume label syntax is incorrect.
The filename, directory name, or volume label syntax is incorrect.
The filename, directory name, or volume label syntax is incorrect.
I have attached copies of timetrex.ini.php, php.ini and timetrex.log (the entries in the log will be most relevant as some entries before that are from the times I was testing from the command line)
I seen an earlier thread about an issue with apache being unable to run php.exe however I created the below test page within my timetrex directory:
Code: Select all
<?php
if ( is_executable( 'C:\workdata\appdata\php\php.exe' ) ) {
echo "Works!\n";
} else {
echo "Does not work!\n";
}
?>
Any ideas what might be wrong?
Cheers